Sensors

Return stop for workpiece carriers with minimum weight of 3 kg

Return stop for workpiece carriers with minimum weight of 3 kg
Advanced version with slim top housing.
For fastening from below

Retrun stops prevent the workpiece carrier from bouncing back when stopping. The use of a backstop is always recommended when workpiece carriers are transported on a transfer system with low propulsive force. This is always the case, for example, with the accumulating roller chain as a conveying medium. The use of backstops is highly recommended at high transport speeds. Because the backstop “locks” or positions the workpiece carrier, a cycle time reduction can also be achieved.

Return stop for workpiece carriers with minimum weight of 3 kg
With protective cap around the return lock latch -> good protection against filth

Retrun stops prevent the workpiece carrier from bouncing back when stopping. The use of a backstop is always recommended when workpiece carriers are transported on a transfer system with low propulsive force. This is always the case, for example, with the accumulating roller chain as a conveying medium. The use of backstops is highly recommended at high transport speeds. Because the backstop “locks” or positions the workpiece carrier, a cycle time reduction can also be achieved.

Return stop for workpiece carriers with minimum weight of 3 kg
Lock latch covers the basic housing -> good protection against filth

Return stop - retrofittable, suitable for ASMR-400 and ASMR-600.
Linear lowering movement.
For workpiece carriers with 40 mm stop rigde wideness.

Return stop for workpiece carriers with minimum weight of 3 kg
Delivery including fastening set 75000000

Return stop for workpiece carriers with minimum weight of 3 kg
Suitable for Bosch Rexroth workpiece carrier WT 2/H and WT 2/F
Delivery including fastening set and distance block
Identical to the Bosch Rexroth Return stop VE 4/RS

Return stop for workpiece carriers with minimum weight of 3 kg
Advanced version with mounting option for inductive proximity switch
Also suitable for lowering the return stop by hand

Return stops prevent the workpiece carrier from bouncing back when stopping. The use of a backstop is always recommended when workpiece carriers are transported on a transfer system with low propulsive force. This is always the case, for example, with the accumulating roller chain as a conveying medium. The use of a return stop is highly recommended at high transport speeds. Because the backstop “locks” or positions the workpiece carrier, a cycle time reduction can also be achieved.
Electrically lowerable return stops are used instead of the normal return stops ASR where reverse transformation can occur. Therefore, the return stop must be lowered so that the workpiece carrier can pass the return stop from the reverse direction.

Electric return stop
Minimum weight of workpiece carrier 2 kg