de

With the help of the product finder quickly to the right product

Technical bases for download

Product
Damping
Conveyor speed v = m/min
Workpiece carrier load (Single WT) m = kg
minimum number of accumulated workpiece carriers imin =
maximum number of accumulated workpiece carriers imax =
Transport system / friction

Do you have a reference product from another manufacturer?
Here you can request our Asutec product name:

ASMEL-410

Home>Products>Stop modules>Stop modules with damping>Stop modules with damping el>ASMEL-410

Stop module with damping ASMEL-410

For stopping and separating of one or more accumulated workpiece carriers on a defined workpiece carrier stop surface.

Technical data

EXECUTION AND WEIGHT

Device design: Basic housing made of hard anodized aluminum and stop plate made of hardened steel. Air damping system, adjustable damping effect
Weights of the devices:
ASMEL-410-DW-09-G5: 4,25 kg

CYCLE TIMES

Time to lower the stopper: 1 seconds
Time to rise up the stopper: 0,3 seconds
Minimum cycle time: 5 seconds

FUNCTION

The electrical separator ASMEL-410 is a separators with damping. The damping is with air and can be finely adjusted via a throttle screw.
Further information are provided in the operating manual.

ELECTRICAL CONNECTION

For normal operation, the separator is connected to the actuator connection (X1 Act) and to the sensor connection (X2 Sens). Both connectors have a size M12x1 and have 5-pins.
Further information are provided in the operating manual.

POWER SUPPLY

24 Volt ± 15%, with reverse polarity protection. If the voltage is higher or lower, the Power LED starts flashing in 0.25 second intervals. No more commands are executed. If the voltage range is between 20V and 28V again, then the Power LED is permanently on. The separator is then ready for use again.

POWER CONSUMPTION

Residual current: 0.1 A
Rated current 2,0 A
The current consumption of the separator takes place via the supply voltage of the actuator-connection (pin 4).

INPUT

High-Pegel > 19 V
Low-Pegel < 8 V

OUTPUTS

High-Level = supply voltage – 1,2 V ( approx. 20 V … 27 V)
Low-Level < 1 V

LEDS

The LED „PW’ (power) lights up green in normal operation
OPEN: The LED “NO” (opened) lights up yellow when the stop module is open (lowered).
CLOSED: The LED “NC” (closed) lights up yellow when the stop module is closed (in upper position).

TEMPERATURE RANGE

+ 5°C up to + 60°C (without accessories)

Variants

No items found

ASMEL-410-DW-09-G5

Electrically controlled stop module with air damping for workpiece carrier load from 20 kg up to 410 kg
Double acting function, 9 mm lowering stroke
Connection G5: 5-pin connector M12x1 for actuators and sensors

ASMEL-410-DW-09-G5-009

Electrically controlled stop module with air damping for workpiece carrier load from 20 kg up to 410 kg
Double acting function, 9 mm lowering stroke, with special stop plate
Connection G5: 5-pin connector M12x1 for actuators and sensors
Basic housing without fastening lugs

ASMEL-410-DW-09-G5-KI

Electrically controlled stop module with air damping for workpiece carrier load from 20 kg up to 410 kg
Double acting function, 9 mm lowering stroke, with tilt stop
Connection G5: 5-pin connector M12x1 for actuators and sensors
Previous page Next page

This website uses Cookies to run necessary features. Additionally, we would like to get insights via Google Analytics to improve our website, if you agree.