Fastening sets

Fastening set, consisting of hammer screws, flange nuts.
For 10 mm profile slot.
Usually for Asutec devices ASR-005

Fastening set A, consisting of screws, hammer nuts, long guide sleeves.
For 10 mm profile slot.
Usually for Asutec devices ASMNG-220

Fastening set B, consisting of screws, hammer nuts, short guide sleeves.
For 10 mm profile slot.
Usually for Asutec devices ASMNG-220

Mounting bracket set, consisting of bracket, screws, hammer nuts and centering bolts for 10 mm profile slot.
For mounting on the section profile.
Usually for Asutec devices ASME-60 with two air connetions.

Fastening set, TS 2 - for mounting under the section with B = 480 mm
Consisting of cross strut profile 45x90, 4x bracket 45x45 + fastening accessories

Fastening set, TS 2 - for mounting under the section with B = 640 mm
Consisting of cross strut profile 45x90, 4x bracket 45x45 + fastening accessories

Fastening set, TS 2 - for mounting under the section with B = 800 mm
Consisting of cross strut profile 45x90, 4x bracket 45x45 + fastening accessories

Fastening set, TS 2 - for mounting under the section with B = 1040 mm
Consisting of cross strut profile 45x90, 4x bracket 45x45 + fastening accessories.
Due to the width of the strut profile, it is recommended to use an additional support profile to prevent the cross strut profile from bending when the stopper is lowered.

Fastening set, TS 2 - for mounting under the section with B = 1200 mm
Consisting of cross strut profile 45x90, 4x bracket 45x45 + fastening accessories.
Due to the width of the strut profile, it is recommended to use an additional support profile to prevent the cross strut profile from bending when the stopper is lowered.

Fastening set, consisting of screws, hammer nuts, centering bolt.
For 8 mm profile slot
Usually for Asutec devices: ASUEL-35-EW-07
(The second centering pin is already present on both sides of the ASUEL-35-EW-07.)